The Rösler swing table blast machine was developed for treating transmission components such as; for example, gears, crown wheels, bevel gears or shafts. The machine is divided into two zones,the externally located work piece loading / unloading zone and the blasting zone. A partition divides the rotating table into two 180° segments. Depending on the required throughput, this machine can be equipped with 2, 4 or 8 satellite stations. While the blast / peening process takes place in one segment, work pieces can be loaded / unloaded in the other segment. The transmission components can be loaded / unloaded by hand or fully automatically. Once the work pieces are placed into the satellites, the main table indexes by 180°. After the special sealing system is activated, the work pieces are clamped by a hold down device, and the blast / peening process starts. At the same time, in the external zone, work pieces can be loaded / unloaded. The work pieces are rotated during the entire blast / peening cycle. Depending on the work piece dimensions, the blast nozzles are capable of being moved with a servo motor, allowing the tracing of the work piece contours and the targeting of specific surface areas.
read more
Highlights
Absolute precision and reproducibility
Improve the life of the component
Reduce fatigue cracks and other signs of age during the operation of components
Contact
X
Thank You for your interest in our product. You will receive the brochure on your mail!
